Click to open expanded view
Jeep Wrangler TJ/LJ 1997-2006, MetalCloak Long Arm Frame Mount System Info & Specs
A long arm suspension needs mounting points that can take the load, and the stock frame was not built for that. This 1/4in plate steel system provides the control arm mounts for MetalCloak long arm control arms. Used with the Long Arm Skid Plate Center Section, the three pieces form a belly pan with built-in approach and departure angles, boat-side styling and recessed hardware, and the chassis becomes stiffer. It works with stock or aftermarket transfer cases. Installation calls for cutting and welding, including welding at the rear axle, and a licensed installer is recommended.
Key Features
- 1/4in plate steel control arm mounting points
- Built-in approach and departure angles
- Boat-side styling with recessed hardware
- Stiffer chassis when used with the center section
- Works with stock or aftermarket transfer cases
- Made in the USA
Specifications
- Material: 1/4in hot-rolled steel plate
- Finish: black powder coat
- Installation difficulty: difficult, licensed installer recommended
- Body modification: cutting and welding
- Install time: 2 to 3 hours
Fitment
- Jeep Wrangler TJ/LJ 1997-2006
In the Box
- Long arm frame mounts
- Weld-in sleeves
- All required hardware
Notes
- Works with both early and late model skid plate center sections, sold separately.
- Installation requires welding at the rear axle.
- A suspension specialist should align the Jeep after a MetalCloak suspension goes in.
MPN 7087 · UPC 810191171263
Recommended for You
- Choosing a selection results in a full page refresh.
!