Jeep Wrangler JL 2018-2026, MetalCloak Duroflex Control Arms, Full Set

A lifted JL that crawls rocks and runs washboard puts steady load on its control arms. Arms that bind as the axles cycle cost you travel and ride quality. This full set uses CNC-formed DOM steel tubing with forged adjustable threaded ends, and every arm carries Duroflex joints, a MetalCloak design enhanced with Kevlar that stays centered and aligned to the frame and axle. The arms are listed at 68 degrees of maximum articulation, where typical arms reach 40. Install the set, adjust the ends to your build, and drive a suspension with no joint maintenance to schedule.

Key Features

• CNC-formed DOM steel tubing in three diameters for lower, front upper and rear upper arms
• Adjustable forged threaded ends, listed at 37% higher fatigue strength than cast ends
• High-clearance bends
• Duroflex joints enhanced with Kevlar, vibration-dampening and self-centering
• 68 degrees of maximum articulation, against 40 degrees for typical arms
• Maintenance-free and easily rebuildable
• Designed for up and down travel

Specifications

• Front and rear lower control arms: 1-5/8in OD x 0.250in wall DOM steel
• Front upper control arms: 1-1/4in OD x 0.187in wall DOM steel
• Rear upper control arms: 1-1/2in OD x 0.187in wall DOM steel
• Finish: gold zinc plated
• Joints: Duroflex with Kevlar, marked with the MetalCloak M on the outer surface
• Joint misalignment: 34 degrees

Fitment

• Jeep Wrangler JL 2018-2026

Notes

• Components have been tested to FMVSS 126 with 37in tires, full body armor and suspension lift.

MPN 7605.1 · UPC 850028646663