Jeep Wrangler JL 2024-2026 & Gladiator JT 2024-2026, MetalCloak Heavy Duty Front Sway Bar Quick Disconnects, 11-12in

A lifted 2024 or newer JL or JT can only use the travel its suspension was built for when the front sway bar is out of the way. Factory end links stay bolted in, and the bar holds the axle back on every ledge and off-camber climb.

These MetalCloak quick disconnects bolt into the factory locations and release the front bar by hand. The rods are 1in OD by .25in wall DOM steel with spherical rod ends and 3/4in mounting pins, and the length adjusts on the vehicle for 2.5in to 5.5in MetalCloak lifts. Bolt plates and stow straps hold the bar and links to the frame while wheeling.

Install takes about an hour with no body modification. Pull the pins at the trailhead, stow the links, and reconnect before the drive home.

Key Features

• Manual quick disconnect for the front sway bar
• 11-12in adjustable length, adjustable on the vehicle
• 1in OD x .25in wall DOM steel rods with machined wrench flats
• Hard chrome plated spherical rod ends with a self-lubricating race
• 3/4in 4130 chromoly mounting pins with bar pin quick clips
• 3/8in laser-cut riser bracket for access to the mounting studs
• Bolt plates and stow straps secure the bar and links when disconnected
• Gold zinc plated, made in the USA

Specifications

• Length: 11-12in
• Rods: 1in OD x .25in wall DOM A513 steel
• Mount studs: 1.25in 4130 steel
• Riser bracket: 3/8in hot-rolled steel
• Rod ends: chromoly steel with self-lubricating race
• Coating: Gold zinc
• Quantity: Pair
• Install time: About 1 hour
• Body modification: None

Fitment

• Jeep Wrangler JL 2024-2026
• Jeep Gladiator JT 2024-2026

For Jeeps without electronic sway bar disconnects. Designed for MetalCloak 2.5in to 5.5in lifts.

In the Box

• Front sway bar disconnect rods (2)
• Riser bracket (1)
• Bolt plates (2)
• Rod ends (4)
• Mount studs (4)
• Stow straps (2)
• Lynch pins (4)

Notes

• Rubicon sway bars may need the bar hole opened to fit the larger hardware.
• MetalCloak recommends a suspension alignment by a specialist after installing MetalCloak suspension parts.

MPN 7425 · UPC 850050509868