Click to open expanded view
Jeep Wrangler JL 2018-2026 & Gladiator JT 2020-2026, MetalCloak Duroflex Axle Bushing Kit, Front Info & Specs
Duroflex control arms do their job at the frame end, but the factory Clevite bushings at the axle end limit how far the arm can twist. This kit swaps those rubber bushings for press-in Duroflex joints with Kevlar fiber in the elastomer, giving 34 degrees of articulation and full 360 degree rotation while still damping noise and vibration. Press them into the factory axle housings, and the control arms move freely at both ends.
Key Features
- Duroflex joints with Kevlar fiber compounded into the elastomer
- Presses directly into the factory axle-side housing
- 34 degrees of articulation, 360 degrees of rotation
- Self-centering design that damps noise, vibration and harshness
- Rebuildable: clean, regrease and reassemble
Specifications
- Press-in housing: 2.0in OD x 1.5in ID x .25in wall DOM A513 steel
- Joint: Vulcanized elastomer with Kevlar fiber
- Articulation: 34 degrees
- Rotation: 360 degrees
- Coating: Raw
- Install time: 2-3 hours
- Body modification: None
Fitment
- Jeep Wrangler JL 2018-2026
- Jeep Gladiator JT 2020-2026
Works only with MetalCloak Duroflex control arms; not recommended for other control arms.
In the Box
- Press-in housings
- Duroflex joints
- Retaining washers
- Retaining clip
Notes
- MetalCloak recommends a suspension alignment by a specialist after installing MetalCloak suspension parts.
MPN 7707 · UPC 810191173045
Recommended for You
- Choosing a selection results in a full page refresh.
!