Longer wheelbase, taller lift, more strain on the factory driveshaft: a 4-Door JL asks a lot of its rear shaft. This heavy-duty replacement has a 2.5in outer diameter with a thicker wall than stock, which gives more clearance at the crossmember and exhaust. It is pre-balanced and pre-measured for each lift height, and serviceable slip shafts with internal seals replace the accordion boot. The 1310 double cardan joints are made in the USA and take grease through zerk fittings. Install it, set the pinion angle, and the rear drive line is ready for MetalCloak 2.5in to 5.5in lifts.
Key Features
- 2.5in outer diameter, with more clearance and a thicker wall than stock
- Pre-balanced and pre-measured to the correct length for each lift height
- Serviceable slip shafts with internal seals instead of the stock accordion boot
- 1310 double cardan joints, made in the USA
- Zerk fittings for grease
- Made in the USA
Specifications
- Diameter: 2.5in
- Joints: 1310 double cardan, standard Spicer 1310 U-joints
- Finish: black paint
- Installation difficulty: easy
- Body modification: none
- Install time: 3 to 4 hours
Fitment
- Jeep Wrangler JL 4-Door 2018-2026
In the Box
- Rear driveshaft
- Replacement yoke
- All required hardware
Notes
- Requires adjustable control arms to set the pinion angle.
- Used with MetalCloak 2.5in to 5.5in lifts.
- A separate 1350 rear driveshaft is available for the 1350 joint version for M220 rear axles.
MPN 7251 · UPC 810191177500