Jeep Wrangler JL 4-Door 2018-2026, MetalCloak Bolt-On 4-Link Long Arm Upgrade System, Duroflex

Fits Jeep Wrangler JL 4-Door 2018-2026

SKU: 7290
In stock and ready for shipping
Price
$4,061
Add To Wishlist
Vehicle Fitment

2018-2026 Jeep Wrangler JL 4dr

Install Instructions
Warning: California Residents

WARNING: Cancer and Reproductive Harm -www.p65warnings.ca.gov

Jeep Wrangler JL 4-Door 2018-2026, MetalCloak Bolt-On 4-Link Long Arm Upgrade System, Duroflex Info & Specs

Many JLs start life on a short arm lift and outgrow it. This system takes a four-door JL from short arms to a full long arm suspension in one box. It includes two upper and two lower Duroflex long arms for the front and the same for the rear, front frame mounts that replace the factory mounts, rear frame-mounted control arm brackets and a 3/16in replacement crossmember. Wheelbase measurements stay more consistent through suspension travel, and pinion angle improves. The Duroflex bushings give bind-free, service-free articulation. Installation means cutting off the factory control arm brackets, so plan the work with a shop that handles suspension builds.

Key Features

  • Two upper and two lower front long arm Duroflex control arms
  • Two upper and two lower rear long arm Duroflex control arms
  • Forged threaded ends on the lower control arms
  • Duroflex bushings for bind-free, service-free articulation
  • Front frame mounts replace the factory mounts: fully welded and boxed, low profile, 1/4in steel
  • Rear frame-mounted control arm brackets in 1/4in steel plate, angled to slide over obstacles
  • 3/16in replacement crossmember
  • Gold zinc finish
  • Made in the USA

Specifications

  • Upper front arms: 1.25in DOM, .1875in (3/16in) wall
  • Lower front arms: 2.0in DOM, .25in (1/4in) wall
  • Upper rear arms: 1.5in DOM, .1875in (3/16in) wall
  • Lower rear arms: 2.0in DOM, .25in (1/4in) wall
  • Frame brackets: 1/4in steel
  • Crossmember: 3/16in
  • Finish: gold zinc

Fitment

  • Jeep Wrangler JL 4-Door 2018-2026

In the Box

  • Front upper long arm control arms (2)
  • Front lower long arm control arms (2)
  • Upper and lower front frame mount brackets
  • Rear upper long arm control arms (2)
  • Rear lower long arm control arms (2)
  • Rear frame-mounted control arm brackets
  • 3/16in replacement crossmember
  • All required hardware

Notes

  • Installation requires cutting off the factory control arm brackets.
  • Built for setups that call for tight wheelbase and pinion angle control.


MPN 7290