A short arm front end changes its wheelbase as the suspension cycles. This system swaps it for long arms on a four-door JL or a Gladiator, which keeps wheelbase measurements consistent through travel and improves pinion angle. The kit has two upper and two lower Duroflex control arms, fully welded and boxed 1/4in steel frame brackets, and a 3/16in replacement crossmember. The upper arms are 1.25in DOM and the lower arms are 2.0in DOM with forged threaded ends. Choose the Crossmember Style that matches your Jeep, since Jeep used both a 2 bolt and a 3 bolt hole pattern. Plan on cutting off the factory brackets, then get an alignment.
Key Features
- Frame-mounted upper and lower 1/4in steel control arm brackets, fully welded and boxed
- Two upper long arm Duroflex control arms
- Two lower long arm Duroflex control arms
- 3/16in steel replacement crossmember
- Duroflex joints enhanced with Kevlar
- Made in the USA
Specifications
- Upper arms: 1.25in DOM, 0.1875in wall
- Lower arms: 2.0in DOM, 0.25in wall, forged threaded ends
- Frame mounts: 1/4in steel, gold zinc finish
- Crossmember: 3/16in steel
Fitment
- Jeep Wrangler JL 4-Door 2018-2026
- Jeep Gladiator JT 2020-2026
In the Box
- Upper and lower long arm Duroflex control arms (2 each)
- Frame-mounted control arm brackets
- Replacement crossmember
- All required hardware
Notes
- Installation requires cutting off the factory front control arm brackets.
- Sold as a complete system. Components cannot be removed or substituted, and returns are not accepted for unneeded components. Each component is available individually.
- Certain JL and JT builds use a different crossmember configuration, so the MetalCloak crossmember may need modifying.
- Professional alignment is recommended after installation.
MPN 7288 (Crossmember, 2 Bolt Hole Pattern)
MPN 7288 (Crossmember, 3 Bolt Hole Pattern)