Jeep Wrangler JK 2007-2018, TeraFlex Prerunner SpeedBump Bump Stop Kit with Frame Bracket, Rear, 3in Lift

Factory bump stops can deform under hard compression, and a lifted JK that bottoms out risks bent axle housing tubes, damaged shocks and crumpled fenders. The right bump stop length and strike pad height protect all of them.

The TeraFlex Prerunner SpeedBump Rear Kit pairs 3 in stroke SpeedBump bump stops with frame mounting sleeves and a 0.75 in lower strike pad kit, for a JK with 3 in of lift and 35 in tires. The composite construction has a progressive rate that softens the impact of bottoming out, and the stops are maintenance-free with no adjustment or tuning.

Weld the mounting sleeves to the frame, bolt on the strike pads, and the rear suspension gets a controlled stop.

Key Features

• Composite construction with a progressive rate reduces suspension compression impacts and harshness when bottoming out
• Maintenance-free, with no adjustment or tuning needed
• Self-lubricating Delrin acetal resin polymer shaft withstands thousands of continuous cycles without wear or abrasion
• External shaft seal wipes and cleans the shaft to keep contaminants out of the SpeedBump housing
• Lower strike pads bolt on
• Rear Prerunner SpeedBump installation requires welding

Specifications

• Stroke: 3in
• Position: Rear
• Lift height: 3in
• Tire size: 35in

Fitment

• Jeep Wrangler JK 2007-2018 (2-door and 4-door)

In the Box

• 3in stroke SpeedBump rear bump stops, pair
• 3in stroke SpeedBump mounting sleeve with clamp kit (4954770)
• 0.75in SpeedBump bump stop strike pad kit, rear lower (1954600)
• All necessary hardware

Notes

• Welding is required to install the rear bump stops.

MPN 1958260 · UPC 843885025108