Trail debris and rock edges aim for the rear corners of a JK, where the stock lights are exposed. This ExoCorner kit pairs aluminum bar rails and 1/8in steel corner plates with LED taillights in molded black ASA housings. Those housings bolt into the stock light positions with no body modification and add reverse LEDs and side-visible running lights. The LEDs are SAE/DOT compliant, and resistors keep the OE turn signal flash rate. Installation takes one to two hours with some drilling and wiring, and the housings can run with or without corner guards.
Key Features
- Molded black ASA LED housings
- 6061 T6 aluminum bar ExoCorner rails reinforce the ExoSkins
- LED taillights with reverse LEDs and side-visible running lights, SAE/DOT compliant
- Resistors retain the OE turn signal flash rate and prevent dash warning messages
- Finned aluminum heat-sink resistors
- Housings can be used with or without corner guards
- Made in the USA
Specifications
- ExoCorner plate: 1/8in cold rolled steel, black powder coat
- ExoCorner rail: 6061 T6 aluminum, Type III black anodized
- LED housing: black ASA (acrylonitrile styrene acrylate)
- Installation difficulty: moderate
- Body modification: some drilling and wiring
- Install time: 1 to 2 hours
Fitment
- Jeep Wrangler JK 2007-2018
In the Box
- ExoCorner rails
- LED molded housings
- LED taillights
- LED side lights
- Rear corner plates
- Resistors and resistor brackets
- All required hardware
Notes
- Comes in black powder coat only.
- Works with the JK Rear ExoSkins for the 2-Door or 4-Door.
MPN 3431 · UPC 850028646441