Lift a JL Wrangler and the factory bump stops no longer protect the axle, the shocks or the fenders. Hard hits on the trail mean bent parts and long drives home.
This TeraFlex kit pairs 2 in-stroke SpeedBump front stops, with a self-lubricating Delrin acetal resin shaft rated for thousands of cycles, with progressive rear foam stops that run 1.5 in longer than stock. Front lower strike pads, spacers and shims set the height for 2.5-3.5 in of lift.
Remove the factory bump stop bell, bolt in the front stops and pop in the rear ones, and the axle has a controlled stop at full compression.
Key Features
- Front SpeedBump stops with self-lubricating Delrin acetal resin polymer shaft
- External shaft seal wipes the shaft and keeps contaminants out of the housing
- Rear progressive foam stops are 1.5 in longer than stock
- Maintenance-free, no adjustment or tuning required
- Bolt-on front stops and strike pads; rear stops pop into factory locations
Specifications
- Lift height: 2.5-3.5 in
- Front stop stroke: 2 in
Fitment
- Jeep Wrangler JL 2018-2026 (2-door and 4-door)
In the Box
- 2 in-stroke SpeedBump bump stops, front pair
- 1.25 in SpeedBump bump stop pad kit, front lower (3 pair)
- 0.25 in adjustment spacers (2 pair)
- Progressive rear foam bump stops, pair
- 2 in bump stop strike pads, rear pair
- 0.5 in bump stop strike pad shims, rear (4 pair)
- Bump stop bracket mounting plate and strap, rear pair
- All necessary hardware
MPN 1958352 · UPC 843885050360