Jeep Wrangler JK 2007-2018 & JL 2018-2026, MetalCloak Duroflex Rear Lower Control Arms, Adjustable

Rear lower arms on a lifted Wrangler carry the axle, take the rock hits and decide how far the rear can droop and stuff. Stock arms are fixed length and typical joints run out of misalignment, which binds the suspension right when it needs to move.

MetalCloak Duroflex Rear Lower Control Arms are CNC formed from 1 5/8in by 1/4in wall DOM steel with high clearance bends, forged adjustable threaded ends and precision locking nuts. Patented Duroflex joints made with DuPont Kevlar fiber at both ends stay centered, dampen vibration and allow 68° of articulation per arm. The arms are lengthened 5/8in for axle position and gold zinc plated.

Set the length, install and align. The rear end works through its full travel and the joints can be rebuilt when they need service.

Key Features

• High clearance bends for tire clearance
• Lengthened 5/8in for rear axle position
• Forged adjustable threaded ends with precision locking nut
• Designed for up and down travel
• Patented Duroflex joints at both ends, made with a proprietary vulcanized elastomer compounded with DuPont Kevlar fiber
• Over 34° of misalignment per joint and over 68° per control arm
• Self-centering joint that dampens vibration
• Low maintenance and rebuildable: pull the bushing, clean it, regrease with Teflon-impregnated synthetic silicone grease and reassemble
• Gold zinc plated for corrosion protection

Specifications

• Position: Rear lower
• Tube: 1 5/8in OD x 0.25in wall DOM steel
• Joint: Proprietary vulcanized elastomer made with DuPont Kevlar fiber
• Finish: Gold zinc
• Install difficulty: Moderate
• Body modification: None
• Install time: 1-2 hours

Fitment

• Jeep Wrangler JK 2007-2018
• Jeep Wrangler JL 2018-2026

In the Box

• Rear lower control arms

Notes

• An alignment by a suspension specialist is recommended after a MetalCloak suspension is installed.

MPN 7003