Jeep Wrangler JK 2-Door 2007-2018, Rock Hard 4x4 Patriot Series Boat Side Rock Sliders

Climbing a ledge in a 2-Door JK, the rocker panels and body mounts are what drag on the rock. Stand-off sliders protect the sill, but their mounts stick out and can hang the Jeep up, and many need welding to install.

The Patriot Series Boat Side sliders run 3/16in steel plate from the body down to the frame rails, so there is one smooth surface to slide on and nothing to catch. Each slider is cut from a single sheet with the end plates welded shut, and two Hi-Lift jack notches per side give safe lift points. A 4in step follows the factory fender lines and makes getting in and out easier.

The mounting bar follows the curve of the body, and the bottom ties into the body mounts with new, longer hardware. Bolt them on with no welding or fender trimming, and take the hard line.

Key Features

• Boat side design: steel plate runs all the way to the frame rails
• Smooth or tread plate surface
• End plates welded shut to keep debris out
• Hi-Lift jack points cut into each slider
• 4in step for entry and exit
• Protects the body mounts along the sides
• Mounting bar follows the curve of the JK body
• Continues the factory fender lines with no gap
• Bolt-on, no welding and no fender trimming

Specifications

• Material: 3/16in steel plate, laser cut from a single sheet
• Step: 4in wide, follows the factory fender lines
• Jack points: 2 Hi-Lift jack notches per slider, 4 total
• Mounting: top bar to the body; bottom to the body mounts with longer, heavier hardware that replaces the factory bolts
• Finish: black powder coat, semi-smooth semi-gloss
• Made in the USA
• Shipping weight: 85 lb
• Shipping carton: 54 x 12 x 5 in

Fitment

• Jeep Wrangler JK 2-Door 2007-2018

In the Box

• Driver and passenger side rock sliders
• Hardware
• Installation instructions

Notes

• A raw, paintable finish is available on request.

MPN RH-6007-S (Smooth)

MPN RH-6007-T (Tread)