Jeep Gladiator JT 2020-2026, Synergy Rear Track Bar Relocation Bracket

A lifted Gladiator rarely tracks the way it did at stock height. The rear axle sits off to one side, the track bar angle gets steep, and the back end wags over bumps. The Synergy Rear Track Bar Relocation Bracket raises the track bar mount on the axle, which lifts the roll center and brings the stock rear track bar back into a workable angle at 3.5 inches of lift. Bolt it to the stock bracket with hand tools, set the bump stop spacing, and the axle sits centered again.

Key Features

• Raises the rear track bar mounting location on the axle to raise the roll center
• Centers the rear axle on 2 to 3 inch lifts without a new track bar
• Lets a stock rear track bar run at 3.5 inches of lift
• Improves rear track bar geometry to reduce the rear end wag caused by a steep track bar angle
• Reduces body roll and improves handling
• Prevents interference between the rear driveshaft and the gas tank skid when used with long travel shocks
• Ties into the stock track bar bracket in multiple locations

Specifications

• Material: 3/16 and 1/4 inch steel, laser cut and CNC formed
• Finish: abrasion-resistant powder coat
• Install: 100 percent bolt-on, no cutting or drilling

Fitment

• Jeep Gladiator JT 2020-2026

Notes

• Requires a minimum of 2 inches of bump stop spacing
• An adjustable rear track bar is recommended for lifts of 3 inches and taller

MPN 8877-01 · UPC 887753143556