Raise a Gladiator and the rear springs have to keep carrying a bed full of gear and a trailer hitch.
Synergy rear lift coil springs were designed from a clean sheet for the JT. The multi-rate design has a soft initial rate, and the ride rate averages the OEM spring rates to maintain payload and towing capacity. This pair gives 3 inch of lift.
Sold in pairs and pre-set at the factory, so they do not sag or set.
Key Features
- Multi-rate coil springs, unique to the JT
- Ride rate is the average of the OEM spring rates to maintain payload and towing capacity
- Coil spring block heights designed around common bump stop spacings
- Frequency balanced and tuned spring rates
- Made in the United States from high-quality steel; abrasion-resistant black powder coat
- Lifetime warranty or guarantee against sagging and breakage
- 165/250 lb/in initial/ride rate, 7.89 inch collapsed length, 21.375 inch extended length, minimum 2 inch bump stop spacing
- Ride height over stock by model: Sport 3 inch, Rubicon 3 inch, Rubicon Diesel 1 inch, Non-Rubicon Diesel 2 inch, Mojave 3 inch
Includes
Fitment
- Jeep Gladiator JT 2020-2026
Notes
- Requires proper bump stop spacing with Synergy 8057-10 Bump Stop Spacers.
- Retains the stock rake of the vehicle. For a level ride, JT Gladiators need a 1 or 2 inch taller spring in the front compared to the rear, depending on model.
- Lift heights are based on fully loaded Rubicon 3.6L vehicles with HD bumpers, winch and full size spare. Actual lift varies by model.
MPN 8865-30 · UPC 887753142092