Jeep Gladiator JT 2020-2026, ORACLE Lighting Flush Mount LED Tail Lights, Standard Lens

Factory tail lights stick out from a Gladiator's bed, and on a narrow trail that is the part most likely to get hit. A damaged lens or a failed reverse light isn't much to deal with at a trailhead, but it is one more repair to carry home.

The ORACLE Lighting Flush Mount LED Tail Lights sit nearly flush with the bed and wrap around the corner, so they protrude far less than the factory units. The reverse light carries 12 high-powered LEDs, the cross-traffic sensor swaps over from the factory assembly, and the V2 design uses double-diffusion for even light with fewer hotspots.

Remove the factory units, move the sensor across, and plug the new lights in. The tail end stays tight to the bed and lit from every rear angle.

Key Features

• Nearly flush wrap-around design that protrudes significantly less than the factory tail lights
• Plug-and-play installation with an enhanced reverse function
• Reverse light with 12 high-powered LEDs
• Signature perimeter lighting
• Factory cross-traffic sensor swaps over into the new lights
• V2 double-diffusion design for smoother, more uniform light with reduced hotspots
• Surge protection with over-voltage, under-voltage and reverse polarity safeguards; improved CAN-bus compatibility

Specifications

• Lens: Standard
• Warranty period: 2 years

Fitment

• Jeep Gladiator JT 2020-2026 (base and LED packages)

Warranty

2 years (extended from 1 year on the V2 design).

Notes

• Jeeps factory-equipped with halogen tail lights may need a small resistor (part 2030-504) tapped into the reverse light wires to avoid shutdown.

MPN 5882-504 · UPC 810030395058