Revolution Gear & Axle

Revolution Gear & Axle supplies ring and pinions, axles, driveshafts and bearing installation kits. Its ring gears here are cut from 8620 steel, and the Dana 44/210mm front 2-cut set uses face hobbed cutting followed by lapping, the style the OE brands use.

The TrailRecon range is 23 ring and pinion sets. For Jeep and Ford: Dana 30, Dana 35, Dana 44 and the newer Dana 44 210mm and 220mm and Dana 35 200mm axles in the Wrangler JL, JK, TJ and CJ, Gladiator JT and Ford Bronco. For Toyota: 7.5, 8.0, 8.2, 8.4, 8.75, 9.0 IFS and 10.5 inch sets for the Tacoma, 4Runner, Tundra, FJ Cruiser, Land Cruiser and Sequoia, with some Lexus GX and LX fitments.

Identify the axle first: model, front or rear, Rubicon or non-Rubicon, and ring gear rotation, standard or reverse. Then check the carrier. The thick ring gear TJ Dana 44 set, for example, fits 3.73 and numerically lower carriers. Pick the ratio; depending on the axle, choices run from 3.73 to 5.38. Each listing gives the pinion spline count and ring gear size, so compare them to the axle. Ring gear bolts are not included, so order them with the gears.

Questions about fit? Send us a note.

Related: Drivetrain | JL 4-Door Drivetrain | JT Drivetrain | JK 4-Door Drivetrain