While the pods can be used in any modified audio system, they’re also easily integrated into your factory sound system by tapping into your Jeep’s rear speaker wires for signal. There’s any easy access point to do this along the floor by the passenger seat which is fully explained in the installation instructions. You then use an amplifier to power the pods. Your fader control will operate both the pods and the sound bar simultaneously, but the dialed-down factory output to the sound bar has been remedied by the JKU-Pods! The entire sound stage is vastly improved throughout the vehicle and your rear passengers can finally hear the music too!
JKU-Pods mount easily to the factory sport cage with included specialty screws. No modifications are needed because the pods mount directly over the cloth and padding. Each pod has a concealed wire-lead hole to hide speaker wires as they exit the pod and slip under the roll bar cover.
30647K: You can get the pods with Kicker Component speakers included. The tweeter holes are pre-cut and ready for the Kicker Component System. You will need to supply your own amplifier, wiring and connectors with this version.